SCIFIT SXT7000 Uživatelský manuál stáhnout pdf (Strana 49)

R. Brake Replacement

Removal

1. Remove covers and water bottle holder (if mounted to the covers). A

Philips screwdriver is used to remove the covers on newer units. For

older units, a 1/8” Allen wrench or socket is required.

2. Remove the cover support (A1546), using a ½” wrench or socket. Four

(4) bolts are located at the top of the support and two (2) at the bottom.

Older machines only had two (2) bolts located at the top.

3. Disconnect both cables connecting to the brake. One (1) cable

connection is located inside the monocoque and connects to the coil on

the bottom of the brake. The other cable runs up the outside of the left

side panel of the monocoque and connects to the brake.

4. Mark the position of the brake on the sides of the monocoque. Four (4)

brake mounting bolts are located on the outside of the monocoque.

5. Loosen the four (4) black 10mm bolts mounting the brake (S1907) to the

monocoque.

6. Back the brake tension bolt off, four (4) to five (5) turns to relieve belt

tension. On newer machines, a 3/8” wrench is used. The older machines

require a 5/32” Allen wrench.

7. Loosen the four (4) bolts that mount the frame spacers (A1131).

8. Loosen the two (2) bolts that mount the tensioning bar for the brake

(A1538) to finger-tight. The tensioning bar will later be used as a handle

to remove the brake.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 64 65

Žádné komentáře

SCIFIT SXT7000 Uživatelský manuál Strana 49